Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for FRP DB003
Summary of Contents for FRP DB003
- Page 1 DB003 40cc Off Road Scooter...
- Page 2 SAFE FOR USE (CAUTION PLEASE!!!) This mark noti es a very important item for safety. Be sure to observe the notice. Do not use 4 cycle engine oil.(otherwise,it cause the plug to be degraded ,the piston ring to seize or the muf er to be clogged.) PROHIBITED ITEMS Do not allow anyone who does not understand this instruction manual to operate the bike.
- Page 3 Do not store, spill or use any gasoline near a re, stove, oven, boiler or other instruments which uses a pilot light or spark.(Other- wise,it may cause an explosion.) Smoking is strictly prohibited while re lling the fuel. While the engine is running or while it remains hot soon after stopping, do not remove the lid of the fuel tank or re ll the fuel.(Be- fore or re lling the fuel, stop the engine and cool it down 2 minutes or more.)
- Page 4 ALWAYS WEAR HELMET&SAFETY GEARS. ALWAYS CHECK THE BRAKE INSTRUMENTS BEFORE RIDING. DO NOT RIDE IN RAINNING, SNOWING DAY, SLIPPERY SUR- FACE,OR UNSTABLE DUE GRAVEL,SAND etc PREGNANT PERSONS SHOULD NOT USE THIS PRODUCT. NEVER USE ALCOHOL OR DRUGS BEFORE OR WHILE OPERAT- DO NOT STOP STOP THE SCOOTER SUDDENLY(Run slowly 3-5minutes after start-up or before stopping.) This bike is not intended for operation on pedestrian, street, highway...
- Page 5 IMPORTANT PLEASE READ BEFORE USING THIS PRODUCT READ THIS FIRST! WARNING DO NOT operate this product in traf c, on wet, frozen, oily or unpaved surfaces or under the in uence of drugs and/or alcohol. Avoid uneven surfaces, potholes, surface cracks and obstacles. DO NOT use a water hose to clean this product.
- Page 6 QUICK REFERENCE SAFETY GUIDE Fuel Safety Mix and pour fuel outdoors away from sparks or ames. Only use a container approved for fuel Do not smoke or allow smoking near the motorcycle while working on the engine, or while the engine is running. Wipe up and clean all fuel spills before starting the engine.
- Page 7 TECHNICAL SPECIFICATION MINI PARTS DESCRIPTION FAST INSTALLATION PREPARATION BEFORE STAT-UP OPERATING AND RUNNING BEFORE RIDING BRAKING OPERATING PROCEDURES CARBURETOR ADJUSTMENT STOPPING BRAKING SYSTEM ADJUSTING THE BRAKES ADJUSTING THE CHAINS MAINTENANCE SCHEDULE STORAGE TROUBLE SHOOTING 9-10...
-
Page 8: Technical Specification
Technical Specification Engine type: 40cc 4-stroke/EPA Fuel: Gasoline >#90 NO OIL MIX!!! Start Mode: Hand Pull Start Brake: Rear disk brake Tire: front tire 4.10-6, rear tire 5.00-6, off-road tire Max Traveling Noise: 45dB Max Load: 160lbs Net Weight: 50 lbs Fuel Capacity: 0.26gal(1L) Driving Method: T8F Chain Packing: Carton... - Page 9 Mini Parts Description Speed control handle Kill switch Gas tank cover Throttle cable Gasoline tank Brake bar Rear tyre Front fender Pull start Chain adjuster Engine Caliper kickstand Front tyre...
-
Page 10: Fast Installation
Fast Installation Install shield. Install plate, put a spacer ring rst, then x it. And insert fender to plate. Fix four screws on handlebar. Preparation Before Start-up 1. Inspect equipment Check all bolts & nuts,brakes,engine etc. 2. Check and clean the air lter The air lter must be often cleaned, or the polluted air lter will lower the out put power of the engine. -
Page 11: Operation And Running
Operation and Running The bike is packed in a cardboard carton. After unpacking. Very the smooth and perfect function of the Bowden cable throttle and both brakes. Fill the fuel tank with fuel. Failure to use the proper oil mix ration will result in Engine damage or which you will be responsible. -
Page 12: Operating Procedures
Braking 1.To brake, release the hand throttle and depress the hand brake levers (on the left and right side of the handlebars). 2.Gradually decrease the engine speed to idle and turn off the kill switch on handlebar . This will turn the engine OFF. Operating Procedures WARNING! -
Page 13: Braking System
When the engine is tested at the factory, the Carburetor is basically adjusted. Further adjustment may be required from time to time, depending on climate and altitude. WARNING! When the engine is idling, under no circumstance should your motor- cycle be moving. If the motorcycle continues to move after idle speed adjustment, contact service center. -
Page 14: Adjusting The Brakes
Adjusting the Brakes How to adjust the brakes The Brakes on the motorcycle should come fully adjusted from the facto- ry. However, it may be necessary to adjust the brake from time to time. 1. With one hand, depress the brake caliper using your thumb and fore nger. - Page 15 The correct tension is achieved by adjusting the chain from its loose position to when it becomes lightly tense. To tighten the chains: 1. Slightly loose the two Axle bolts on both sides of the rear wheel. Then slowly adjust the two chain adjusting 2.Occasionally rotate the rear wheel to make sure chain is...
-
Page 16: Troubleshooting
Storage If the bike isn't used for a long time, it must be maintained as follows: 1. Remove the fuel in the tank and in the carburetor, close the chock totally, draw the starter 3-5 times. 2. Use the soft cloth with engine oil to clean the surface of the engine, smear wax on the frame and put the engine to the dry and windy place for the next use. - Page 17 4) Maybe the fuel strainer is blocked by dust. 5) The body or the top of the shaft has oil leakage and air leakage. 4. The gasoline engine stops suddenly when running. 1) Run out of gasoline. 2) The high-voltage wire drops. 3) The spark plug has accumulated carbon or has been broken through.
Need help?
Do you have a question about the DB003 and is the answer not in the manual?
Questions and answers