INVENTABLES X-Carve Pro Manual page 6

● Using a 2.5mm allen wrench take off the 3 screws that hold the X limit switch bracket in
place
● Unplug the switch Molex connector
● Using a 3mm allen wrench remove the screw holding in the limit switch
● Replace with a new switch and add a zip tie to secure the cable
Y-axis
● Use a 2mm allen wrench and take off the cover plate on the front of the Y axis
● Using a 2.5mm allen wrench take off the 2 screws that hold the limit switch bracket
● Unplug the switch Molex connector
● Using a phillips head screwdriver and pliers remove the screw and locknut holding in the
limit switch
● Replace with a new switch and add a zip tie to secure the cable
Z-axis
● Use a 2.5mm allen wrench and take off the plastic cover on top of the Z axis.
© Inventables, Inc.
5