Maintenance For Linear Rails And Ball Screws - Grease - INVENTABLES X-Carve Pro Manual

Recommended Parts/tools:
● Dust filter assembly - SKU 30875-36
Maintenance interval
● Check weekly

Maintenance for linear rails and ball screws - grease

The linear rails and ball screws on your X-Carve Pro come pre-greased from the factory.
Generally, customers should not need to regrease the linear guides or ball screws before 6
months of regular use. However, we recommend that the customer check the grease levels
every few months. This can be done by touching the rail after sliding back and forth to see if the
rail is slightly greasy. If not, then lubrication is low and should be replenished.
We recommend using the Inventables approved grease and grease gun SKU: 30875-30
Note:
1. X and Z-axis has 4 guide blocks that require grease
2. Each Y-axis has 2 guide blocks that required grease
© Inventables, Inc.
2