Advertisement
Available languages
Available languages
INSTRUCTION MANUAL OF ELECTRONIC DIGITAL SAFE
1. USEFUL INFORMATIONS:
Read the instructions carefully before using the safe.
The safe is supplied with a service code "1234"
Keep your personal code in a safe place.
Do not use personal data like birthdays, telephone numbers...etc.
It will be convenient to replace the batteries every year using a 9V alkaline battery type LR61.
The safe is supplied with 2 emergency keys to use in case of emergency. Please, never leave the keys in the
safe itself.
If the safe will not be used for a long time, please, take out the batteries.
Before installing the safe, please, verify the opening and closing with the door open utilizing a service code
1234.
2. INITIAL SETTINGS:
The safe is delivered with the door unlocking. Put the safe in his normal position, so the spring open the door.
Remove the battery cover located on the back of the door and install the 4 batteries included, ensuring they are
fitted with correct polarity (+ and -) and close the battery compartment. One beep tone will sound and all LED
will shine, to indicate that the electronic system is activated.
3. OPENING/CLOSING USING THE SERVICE CODE "1234" (with door open and bolts
retracted)
Close the door completely and press the "LOCK" key. The bolts will be automatic out. The red LED will
shine to signal that the door now is locked.
Digit the service code "1234" and the door will be automatic open. The green LED will shine to signal that the
door now is opened.
4. PERSONAL CODE PROGRAMMING (with the door open and the bolts retracted)
Press twice the "CLEAR" key. The green and red LED will shine.
With both LED illuminated, digit your personal code with a minimum of 3 to maximum of 6 digits and press
"LOCK" key
Digit your personal code again and press the "LOCK" key. The green and red LED will turn off and your
personal code is programmed.
If errors have been made while setting your new code, repeat the procedure for setting your new personal code
again, starting from the beginning.
*
Before close the safe, it is advisable to check that everything it is OK by operating the opening and closing
procedure for a number of times with door open. If all it will be good, you can close the door.
5. TO CLOSE:
Close the door completely.
Press "LOCK" key. The bolts will be automatic out and the red LED will shine to signal that the door now is
locked.
*
If yellow indicator light shine after red light, that means the bolts are blocked by closing and the bolts return in
the open position. Please, remove the obstacle and repeat the operation from the beginning.
6. TO OPEN USING A PERSONAL CODE:
Digit your personal code. The bolts will be automatic retract and the green indicator light will shine.
If something block the return of the bolts, yellow indicator light shine after green light. This could happen, for
example, if the bolts are bended and they force on the internal part of the frame. In this case, it is necessary to
push the door and repeat the opening procedure from the beginning.
*After 4 attempts with incorrect codes, the keyboard will be disabled for 15 minutes. After 15 minutes, you can use
the safe again. Before wait-time, it will be possible to open the door using the emergency key.
RANGER SAFE MOD.
RSE
Advertisement
