1. Manuals
  2. Brands
  3. D'Orly Manuals
  4. Nail Gun
  5. RH Series
  6. Manual

D'Orly RH Series Manual

Hide thumbs Also See for RH Series:
Table of Contents

Advertisement

Quick Links

Download this manual
MANUAL
DA64FN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RH Series and is the answer not in the manual?

Questions and answers

Related Manuals for D'Orly RH Series

Summary of Contents for D'Orly RH Series

  • Page 1 MANUAL DA64FN...
  • Page 2 Operating Instruction Operating Instruction and safety manual 34°Angle Finish Nailer Model: DA64R IMPORTANT: Please read and fully understand this manual for information relating to protecting your safety and preventing equipment problems. And retain this manual for future reference. DESCRIPTION 1.Air Inlet Coupler 2.
  • Page 3 GENERAL SAFETY RULES For multiple hazards, read and understand the safety instructions before installing, operating, repairing, maintaining, changing accessories on, or working near the air tool. Failure to do so can result in serious bodily injury. Only qualified and trained operators should install, adjust or use the air tool. Do not modify this air tool.

  • Page 4: Additional Safety Instructions For Pneumatic Power Tools

    The characteristic vibration values for the fastener driving tool have been determined in accordance with ISO 8662-11:1999 and EN 12096 ¨C Measurement of vibration in hand-held power tools - Part 11: Fastener driving tools(see specifications). This value is a tool-related characteristic value and does not represent the influence to the hand-arm-system when using the tool. An influence to the hand-arm-system when using the tool will for example depend on the gripping force, the contact pressure force, the working direction, the adjustment of compressed air supply, the workplace and the work piece support.

  • Page 5: Residual Risks

    In addition, fastener driving tool is fitted with a safety yoke which enables the driving operation to be carried out only after the safety yoke of the tool is pressed against a work piece, These tools are marked with an inverted triangle ▽behind the serial number and are not permitted for use without an effective safety yoke.

  • Page 6: Noise And Vibration

    NOISE AND VIBRATION INTENDED USE Noise according to EN 12549:1999 and EN ISO 4871 The tool can be used for the purposes listed below: A-weighted sound pressure level LPA=91.1dB(A),KPA=2.5dB Finish and trim(Interior and exterior),Door and window architraves and moulding, Door jambs, Sound power level LWA=104.1dB(A),KWA=2.5dB Skirting boards, Crown mouldings, Fascia boards,...

  • Page 7: General Maintenance

    If the fastener is driven into an excessive depth, reduce the air pressure in increments of 0.5 bar until the result is satisfactory. It is preferred to adjust the depth adjustment knob to reach the good fastening effect. Work with the lowest possible air pressure. This will give you three significant advantages： 1.

  • Page 8: Troubleshooting

    2. Check all screws, nuts, bolts, and pins on the tool. If any of these are loose, they must be tightened with the appropriate size wrench. 3. Press the safety yoke against a workpiece to ensure that it moves smoothly. 4.
  • Page 9 pARts lIst Description Description Description Description Bolt Bumper Trigger valve guide Fixed cover Axle sleeve Cylinder cover washer Spring O-ring 9 x 1.8 Gun body O-ring 2.5 x 1.5 Retainer ring Air deflector Rubber washer Switch valve stem Drive nail slip Bolt M5 x 25 O-ring 1.7 x 2 O-ring 18 x 2.65...

This manual is also suitable for:

Da64fn

Table of Contents