Advertisement

Quick Links

HARMONIA
Manual volume: E 0.1

Advertisement

Table of Contents
loading

Summary of Contents for cadenbach HARMONIA

  • Page 1 HARMONIA Manual volume: E 0.1...
  • Page 2: Safety Precautions

    If you place several systems on top of one another, use straps to secure them against movement. • Only use accessories which have been tested and approved by Cadenbach Acous- tics for assembly and mobile applications. Pay attention to the correct application and maximum load capacity of the accessories.
  • Page 3: Product Description

    Cradle attachment and precise angling. Even full active equipped HARMONIA is still light wight and offers in all version more than 136 dB SPL at 1 meter. This enables the system to be used as main Loudspeaker system either as single speaker or in multiple horizontal and also vertical speaker array arrangement.
  • Page 4 HARMONIA 12 inch FIR point source loudspeaker Data Technical Specifications Transducers Frequency and Phase response • Low frequency: 12 inches • Usable frequency range: 52 Hz - 22 kHz ( 1 ) (320 mm) Neodymium • Free field frequency response: 75 Hz - 19.5 kHz •...
  • Page 5: Audio Specifications

    HARMONIA 12 inch FIR point source loudspeaker Data Technical Specifications Internal Amp module Ac Power connection • Type of output stage: free floating • Powercon 25 A blue in and white link modulator FM out put power stage (max 12,6 A link) •...
  • Page 6 HARMONIA 12 inch FIR point source loudspeaker Data Measurements Frequency response with FIR Filter of HARMONIA Phase response FIR linear phase Filter of HARMONIA www.cadenbach.eu...
  • Page 7 2+/- CH2 System setups: HARMONIA-S2 Typical starter system using 2 x HARMONIA-12UP passive per side with 2 x TEUTAES sub on the ground with 2 x PAX-P16 Amp + 1 x HEIMDALL D05 FIR Controller. Same Amping can double the speakers to run.
  • Page 8 12 inch FIR point source loudspeaker Save operating Protecting your speaker HARMONIA speakers may be used in combination with Cadenbach Acous- tics PAX Amplifiers and Cadenbach Acoustics HEIMDALL controller. In general, audio signals must not be over driven. This may be caused by mixing consoles, equalizers, effect equipment, etc.
  • Page 9: Manufacturer's Declarations

    We herewith declare that said products are in conformity with the provisions of the respective EC directives including all applicable amendments. A detailed declaration is available on request and can be ordered from Cadenbach Acoustics. WEEE Declaration (Disposal) Electrical and electronic equipment must be disposed of separately from normal waste at the end of its operational lifetime.

Table of Contents