Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for cadenbach HEBE
Summary of Contents for cadenbach HEBE
- Page 1 HEBE Manual volume: E 0.1...
-
Page 2: Safety Precautions
If you place several systems on top of one another, use straps to secure them against movement. • Only use accessories which have been tested and approved by Cadenbach Acous- tics for assembly and mobile applications. Pay attention to the correct application and maximum load capacity of the accessories. -
Page 3: Operation
It also provides mounting points for easy horizontal and vertical cradle attachment. Even full active equipped HEBE is still light wight and offers up to 128 dB SPL at 1 meter. This enables the system to be used as main Loudspeaker system for small ap- plications either as single speaker or in multiple horizontal and also vertical speaker array arrangement. - Page 4 HEBE 6.5 inch FIR point source loudspeaker Data Technical Specifications Transducers Frequency and Phase response • Low frequency: 6.5 inches • Usable frequency range: 53 Hz - 21.5 kHz ( 1 ) (170 mm) Neodymium • Free field frequency response: 78 Hz - 21 kHz •...
-
Page 5: Audio Specifications
HEBE 6.5 inch FIR point source loudspeaker Data Technical Specifications Internal Amp module Ac Power connection • Type of output stage: free floating • Powercon 25 A blue in and white link modulator FM out put power stage (max 12,6 A link) •... - Page 6 HEBE 6.5 inch FIR point source loudspeaker Data Measurements Frequency response with FIR Filter of HEBE Phase response FIR linear phase Filter of HEBE www.cadenbach.eu...
- Page 7 Systems System setups: HEBE-S1 Typical starter system using 4 x HEBE-7P passive per side with 1 x TETHRA sub on the ground with 2 x PAX-P16 Amp + 1 x HEIMDALL D05 FIR Controller, same Amping can double the speakers to run.
- Page 8 6.5 inch FIR point source loudspeaker Save operating Protecting your speaker HEBE speakers may be used in combination with Cadenbach Acoustics PAX Amplifiers and Cadenbach Acoustics HEIMDALL controller. In general, audio signals must not be over driven. This may be caused by mixing consoles, equalizers, effect equipment, etc.
-
Page 9: Manufacturer's Declarations
We herewith declare that said products are in conformity with the provisions of the respective EC directives including all applicable amendments. A detailed declaration is available on request and can be ordered from Cadenbach Acoustics. WEEE Declaration (Disposal) Electrical and electronic equipment must be disposed of separately from normal waste at the end of its operational lifetime.