Advertisement
►FAQ
1.Why is the pod not discovered by other equipment when it's not used for a long
time?
A: In order to save battery enenrgy .the pod will go to sleep when it detects no data for
1 minute. Normal broadcasting will resume when the device is used
2.Why doesn't the indicator light illuminate when reinstaling the battery?
A: It's possible the battery connector is covered with foreign contaminate or the spring
is not pushed up.
If the connector is clean and sprung-up, replace the battery with a brand new
battery.(battery model is CR2032-3V)
If not solving the problem.please contact online technical support.
3.Why can't the pod be found by other equipment ?
You should check:
Check the pod is in the correct mode. Red:Cadence, Green: Power Trainer.
•
Whether the software is compatible.
•
Whether there are any inductive magnets causing interference.
•
If the battery is dead, replace it with a new one.
•
If not solving the problem,please contact online technical support.
•
4.ls there any delay in the data of the pod?
The trainer pod uses geomagnetic sensor measurement data, abandoning the traditional
magnet sensing scheme, the installation is more convenient, but there is a certain delay
in calculating the data, but the main reason for data display delay is that the device uses
an averaging algorithm to smooth the data.
5.How many hours can the trainer pod be used?
The battery life is about 400 hours( there will be differences due to the infuence to
temperature and use environment)
Advertisement
