Advertisement
4.We will complete the power calibration by adjusting the resistance.
step 1.Turn the adjusting screw to ensure that the tire and the roller just touch, this is
"0 resistance"
step2. After reaching "0 resistance", We suggest you make the tires fully stressed by
turning the adjusting knob for 0-3 laps. The greater the number of turns, the greater
the resistance.
step3. Enter the number of laps in the Onelap Utility APP
►Device connection instructions
Indicator Light
Flashing Green Light
Flashing Red Light
Alternatively Flashing Red
& Green
1.The pod will only start sending Bluetooth broadcasts after it is properly installed
and woken-up. Then, you can use the corresponding device or APP to search and
connect.
Status
Speed data is being broadcast over
bluetooth.*
Cadence data is being broadcast over
bluetooth.*
Device Battery Low*
Advertisement
