Advertisement
Quick Links
INTEGRATED SYSTEM 2000
SI-16 INPUT PROCESSOR
System Control Processor
Installation and Specification
1. General:
The SI-16 sub-controller provides sensor interface and output controls for system integrators in
security/access control and other application. The controller has 16 input channels for supervised contact
monitoring and 2 form-C contacts for load switching. In addition, 2 digital inputs may be used for tamper
and UPS status monitoring. The sub-controller requires either 12Vdc or 12Vac for power.
Imron Corporation 15375 Barranca Pkwy, Suite B-106
Irvine, CA 92618 Phone 949-341-0947 Fax 949-341-0949
Advertisement
Related Manuals for Imron Corporation SI-16
Summary of Contents for Imron Corporation SI-16
- Page 1 Installation and Specification 1. General: The SI-16 sub-controller provides sensor interface and output controls for system integrators in security/access control and other application. The controller has 16 input channels for supervised contact monitoring and 2 form-C contacts for load switching. In addition, 2 digital inputs may be used for tamper and UPS status monitoring.
-
Page 2: Communication Wiring
Observe POLARITY for 12Vdc application! 3. Communication Wiring: The SI-16 communicates to host via a RS-485 interface, which may be configured for either 2-wire or 4- wire operation. The interface allows multi-drop communication on a single bus of up to 4,000 feet (1,200 m). -
Page 3: Relay Outputs
Transient clamping must be provided to protect the contact and to reduce EMI emission. Use sufficiently large wires for the load current to avoid voltage loss. Imron Corporation 15375 Barranca Pkwy, Suite B-106 Irvine, CA 92618 Phone 949-341-0947 Fax 949-341-0949... -
Page 4: Dip Switch Usage
ADDRESS 24 ADDRESS 25 ADDRESS 26 ADDRESS 27 ADDRESS 28 ADDRESS 29 ADDRESS 30 ADDRESS 31 2,400 BPS 9,600 BPS 19,200 BPS 38,400 BPS NOT USED Imron Corporation 15375 Barranca Pkwy, Suite B-106 Irvine, CA 92618 Phone 949-341-0947 Fax 949-341-0949... -
Page 5: Specification
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Imron Corporation 15375 Barranca Pkwy, Suite B-106 Irvine, CA 92618 Phone 949-341-0947 Fax 949-341-0949... -
Page 6: Warranty
This product is not intended for, nor is rated for operation in life-critical control applications. Imron Corporation is not liable under any circumstances for loss or damage caused by or partially caused by the misapplication or malfunction of the product. Imron Corporation's liability does not extend beyond the purchase price of the product.