Page 3
CE Compliant UL & ULC Recognized • UL294 • UL294B • UL1076 & ULC/ORD 1076 • UL2610 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
1 Buzzer Output (open collector) per reader port • Buzzer output can be repurposed for 2-wire LED control 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Page 5
IMRON IC2 Hardware Manual Part II Hardware Layout Hardware Layout Figure 2.1: IC2 Diagram 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Input 2 Input 2 TB5-1 Input 2 Return IN2G TB6-4 Input 3 Input 3 TB6-3 Input 3 Return IN3G 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
OUT 4 - NO TB9-5 Common OUT 4 - C Relay K4 Connection TB9-6 Normally Closed OUT 4 - NC 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Reader 2 Device Connections Beeper TB11-4 (Buzzer) Control Green LED TB11-5 Control TB11-6 (Reader Power) Table 2.1: IC2 Terminal Connections 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Page 9
Note: RS485 termination jumpers (J2, J3, J4, & J6) are shipped from the factory in the OFF (termination disengaged) position. Only turn ON termination if the IC2 is at the end of the serial bus. 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Relay OUT 2 (K2): ON = Energized Relay OUT 3 (K3): ON = Energized Relay OUT 4 (K4): ON = Energized 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Page 11
“Specifications” section for more information. The coin cell battery power level is monitored and a low battery condition will generate an event message. 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Page 12
Eight holes are provided for mounting the IC2. Mount at least 0.25 inches above the conductive surfaces. One mounting hole is plated for connecting to Chassis (Earth) ground. Figure 2.3: IC2 Mounting Holes [inches (mm)] 2022 IMRON CORPORATION This manual contains confidential information and may only be reproduced or distributed with the written consent of IMRON CORPORATION...
Page 13
IMRON Corporation recommends the use of isolated, continuous power supplies only. In the case of over-current, solid-state fuses integrated on the IC2 panel will ‘trip’ to protect the components of the panel.