Fisher & Paykel SINGLE DISHDRAWER DD24STX6PX1 Installation Manual page 14

SINGLE AIR GAP INSTALLATION
1
2
14
PLUMBING & ELECTRICAL CONNECTION
Install your single Air Gap Kit to the
benchtop like shown.
Refer to 'Plumbing & electrical
considerations' for minimum
install heights.
Secure the drain hose to the supplied
hose joiner and fit to the Air Gap Kit.
Ensure hose is routed straight to the
joiner, removing excess drain hose
if necessary.
Unplug or drill out the waste tee before
securing to sink trap or waste tee.
3
4
Ensure the supplied rubber washer is
fitted to the coupling before connecting
the inlet hose to tap.
Tighten using a spanner or pliers,
avoiding over-tightening.
Do not turn water supply on. The
DishDrawer™ Dishwasher must be
powered on for the flood protection
feature to be enabled.
Plug product in.