Table of Contents
Advertisement
4.0
MAINTENANCE AND SERVICE
Properly maintained, your fire pit will provide you with many years of trouble free service. To
enjoy years of outstanding performance from our fire pit, make sure you perform the following
maintenance and service activities on a regular basis:
4.1 Maintenance
The owner may perform the following tasks. If you are uncomfortable performing any of the listed
tasks, please call Breck Ironworks or authorized dealer for a service appointment.
1. Keep fire pit covered at all times when not in use. Allow fire pit proper time to cool, may
take several hours depending on environmental factors.
2. Keep any debris out of fire pit - after fire pit is properly cool remove any debris or clean as
needed
3. Visually inspect components for any signs of damage or corrosion. If damage is detected, do
NOT operate and call a qualified service technician to repair.
4. Soot can build up on logs through normal use. This is more likely to occur when using LP
gas. The soot can be cleaned off using a dry bristle brush or cloth. Take care while cleaning
the logs as they can become damaged if mishandled.
CAUTION: Any tampering or modifying with the Fire Pit is dangerous and voids all
warranties.
4.2 Service
We recommend annual service by a qualified service technician.
1. Annually, fire pit parts should be inspected for proper working order or signs of damage or
corrosion by a qualified service technician. Inspection should include but not be limited to:
log set, wire mesh, stainless steel burner ring, heat shield, flex hoses, base assembly, gas
valve, on/off valve key and lava rock placement.
2. A qualified service technician should clean fire pit annually.
3. Any component that is found faulty must be replaced with an approved component before
use.
CAUTION: Any tampering or modifying with the Fire Pit is dangerous and voids all
warranties. All repairs should be done by a qualified service person.
Owner's Manual
4.0 Maintenance and Service
Page 4-1
Advertisement
Table of Contents
