Page 2
INFP1419SAT-750 OM 8/11/03 10:37 AM Page 2...
Page 3
INFP1419SAT-750 OM 8/11/03 10:37 AM Page 3 SAT-750 O Table of Contents Introduction Unpacking the Speaker Placement Wall-Mounting the Satellites Speaker Connections Operation Maintenance and Service Specifications WNER ’ S UIDE SAT-750...
In 6 or 7 channel configurations, place the rear channel(s) behind the listening position, as shown in Figures 2 and 3. NOTE: An Infinity powered subwoofer will add impact and realism to both music and film soundtracks. Contact your Infinity dealer for recommendations on subwoofer models for your application.
8/11/03 10:38 AM OUNTING THE The SAT-750 satellites are designed to be mounted on the wall. There is a wall bracket for each satellite speaker. Each speaker bracket will require (2) 1-1/2, " #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2, "...
Surround Modes When using the system in a Dolby* Digital or DTS home theater system, make sure all SAT-750 speakers are set to “Small” . When using the SAT-750 in a Dolby Pro Logic* home theater system, make sure the receiver’s center channel mode is set to “Normal.”...
Page 7
INFP1419SAT-750 OM 8/11/03 10:38 AM Page 7 OTES...
Page 8
Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com * Trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. Infinity is a registered trademark, and Total Solutions and MMD are a trademarks, of Harman International Industries, Incorporated.
Need help?
Do you have a question about the SAT-750 and is the answer not in the manual?
Questions and answers