Wardrobe Doors Direct HIGH LEVEL SHELF WITH HANGING RAIL & CENTRE SUPPORT POLE Installation Manual

HIGH LEVEL SHELF WITH HANGING RAIL
PACK
E
& CENTRE SUPPORT POLE
INSTALLATION GUIDE
This information sheet provides details of how to install an internal high level shelf with hanging rail and centre
support pole. Please take time to read it through fully prior to the installation of your sliding wardrobe doors.
This pack contains:
• Shelf
(l)1600/2000/2400mm x (w)450mm x (d)18mm
• 2 x side shelf bearers
(l)430mm x (w)87mm x (d)18mm
• 1 x back shelf bearer
(l)1600/2000/2400mm x (w)87mm x (d)18mm
• Hanging rail
(l)1600/2000/2400mm
• Support pole
(l)1750mm (including fixing brackets)
• Fixings - 10 x wallplugs; 10 x 40mm screws; 8 x 30mm
screws; 2 x hanging rail brackets; 8 x 15mm screws;
self-adhesive screw head cover caps
• Drilling template
1. Measuring and cutting to size
Measure the width of the space you require the shelf
and hanging rail to span. If this is less than the length of
the shelf supplied, cut the shelf and longest shelf bearer
down to the length required.
TIP
When cutting the shelf and shelf bearer to length
use masking tape along the cut lines to prevent the
laminate surface from chipping. Carefully remove
the tape after you have finished cutting.
2. Fixing the shelf bearers and shelf
The shelf should be positioned so that its underside
is at a height of 1750mm above the floor of the
wardrobe. Using a spirit level, draw a pencil line on the
back and side walls at this height to indicate where the
underside of the shelf will sit.
On each of the shelf bearers, mark the position for
drilling pilot holes for fixing the bearers to the back and
side walls of the wardrobe – see the diagram on page 2.
We advise that the pilot holes are countersunk so once
1
3
1 - Shelf
2 - Back shelf bearer
3 - Side shelf bearers
4 - Hanging rail
5 - Support pole
Tools required (not supplied)
• Electric drill, 2mm diam. wood drill bit and
6mm diam. masonry drill bit
• Crosshead screwdriver
• Handsaw (with appropriate blade for
cutting MFC)
• Hacksaw (32tpi blade recommended)
• Spirit level
• Bradawl
• Tape measure
• Pencil
1
4
3
5
2