Panasonic KX-FMC230 Operating Instructions Manual page 75

Signaling your pager when you receive a
This feature allows your unit to call your pager when your unit receives a fax message.
Press (MENU).
1
Display:
K G @
2 Press , then
Press (START/COPY/SET).
3
4 Press or to select "ON".
¡If this feature is not required, select "OFF".
Press (START/COPY/SET).
5
6
Enter your pager number.
¡If this feature does not work properly, press
(REDIAL/PAUSE) more than once at the end of
your telephone number to extend the paging
time.
If you wish to display a message on your pager,
enter the message after your pager number and
pause(s).
Programming methods may vary depending on
the pager company. Contact your pager company
for details.
¡You can enter a total of 46 digits and/or pauses.
Press (START/COPY/SET).
7
Press (MENU).
8
Note:
¡This feature is not available when the receive mode is
set to the TEL mode.
SYSTEM SET UP
.
FAX PAGER
Ÿÿ
MODE=OFF [
Ÿÿ
MODE=ON [
NO.=
SETUP ITEM [ ]
Dial keypad
1 2 3
4 5 6
7 8 9
] 0
]
(REDIAL/PAUSE)
(START/COPY/SET)
Receiving Faxes
fax!
(MENU)
75