ZHONGSHAN ETECH H-Series Owner's Manual page 10

!
This vehicle is equipped with a built-in charger. This charger is mounted under the driver's seat beside the
batteries. A circuit must be dedicated to the charger. Information regarding appropriate circuit protection may be
found in the charger manual.
The charger output wires (DC cord) are connected to the batteries .Before beginning to charge the batteries, turn
the power key to the OFF position. To charge the batteries, just plug the charger (AC plug) into a dedicated and
grounded AC receptacle.
∆
NOTE ...
This section of the vehicle manual contains important information about the use and care of the
charger that has been included with the vehicle. Additional detailed information is included in the manual that is
included with the charger. It is important to read and understand the information in the charger manual.
∆
NOTE ...
Batteries must be properly charged to achieve maximum performance. Battery life will be
significantly reduced due to undercharging or overcharging the batteries. For a detailed description of the battery
charging cycle and procedure, refer to the instructions in the charger manual.
∆
CAUTION ...
The charger will automatically start shortly after plug insertion and it will automatically stop
when the batteries are fully charged. When charging is complete, unplug the charger plug from the AC
receptacle. Then the vehicle may be used.
∆
WARNING ...
DO NOT direct heavy water spray on the charger when cleaning the vehicle. Make sure
the AC plug is dry before charging the vehicle in order to avoid an electrical shock.
all rights reserved
4. CHARGER INSTALLATION AND USE
! 10 OWNER'S MANUAL 2019-O-M-001