Safety And Warnings - Fisher & Paykel PROFESSIONAL EB30PSX1 Installation Manual

Electric Shock Hazard
Failure to follow this advice may result in
electrical shock or death.
• Before carrying out any work on the electrical
section of the appliance, it must be disconnected
from the mains electricity supply.
• Connection to a good ground wiring system is
absolutely essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician.
Cut Hazard
Failure to use caution could result in injury.
• Take care – some edges are sharp.
Fire Hazard
Failure to follow this advice may result in a fire
causing death or serious injury.
• Do not use adapters, reducers, or branching
devices to connect this appliance to the mains
power supply.
WARNING!
To reduce the risk of fire, injury to persons or damage when using the appliance, follow the
important safety instructions listed below. Read all the guidance before using the appliance.
Servicing
Do not repair or replace any part of the appliance unless specifically recommended in
z
the user guide. All other servicing should be undertaken be a Fisher & Paykel trained and
supported service technician or qualified person.
WARNING!
!
WARNING!
!
WARNING!
!

SAFETY AND WARNINGS

General
Before connecting the appliance to the electrical supply make sure that the voltage and
z
frequency listed on the data plate correspond with the household electrical supply. If in
doubt, consult a qualified technician.
The appliance must be properly installed before operation to ensure that no electrical
z
components are accessible. Ensure that power is not supplied to the appliance while
installation work, repairs or maintenance is performed.
Be certain your appliance is properly installed and grounded by a qualified technician.
z
To guarantee the electrical safety of this appliance, continuity must exist between
the appliance and effective grounding system. It is imperative that this basic safety
requirement be met. If there is any doubt, have the electrical system of the house checked
by a qualified electrician. The manufacturer cannot be held responsible for damages
caused by the lack, or inadequacy, of an effective grounding system.
Do not use an extension cord to connect the appliance to electricity. Extension cord
z
doesn't guarantee the required safety of the appliance (danger of overheating).
Install or locate this appliance only in accordance with the provided
z
installation instructions.
Installation work and repairs must be only performed by a trained technician in
z
accordance with national and local safety regulations. Repairs and other work by
unauthorized persons could be dangerous and may void the warranty.
Only use original spare parts. Only then can the manufacturer guarantee the safety of
z
this machine.
Never open the outer casing of the appliance. Tampering with electrical connections or
z
components and mechanical parts is dangerous and may cause machine damage.
If the machine is installed in combination with other appliances, a protective base should
z
be installed between the appliance and the unit.
Do not install or use outdoors even if installed in the display cabinet.
z
To protect against fire, electric shock and injury to persons do not submerge the cord or
z
plugs in water or other liquids.
To reduce the risk of injury, do not drape cord over the counter top or table top where it
z
can be pulled on by children or tripped over unintentionally.
Do not let the cord hang over the edge of a table or counter, or touch hot surfaces.
z
Do not operate any appliance with a damaged cord or plug, or after the appliance
z
malfunctions or has been damaged in any manner.
Return appliance to an authorized service facility for examination, repair or adjustment.
z
To disconnect turn the machine off, switch off the main switch then remove the plug from
z
the wall outlet.
Do not allow children and animals to stop or linger near the appliance when it is pulled
z
out of the cabinet.
Do not leave the machine pulled out of the cabinet when it is being used.
z
Do not leave the machine pulled out of the cabinet when it is not needed.
z
Install the machine according to the instructions in the handbook to guarantee there are
z
no spills when it is pulled out from the cabinet.
The rails fixing panel must have a thickness suited to the fixing screws supplied standard.
z
The panel material must be suited to the machine weight of approximately 55lb (25kg).
z
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to
change at any time. For current details about model and specification availability in your country,
please go to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
3