Installation Instructions - OENOPRO TGLSST-RHSSSH-SZ Instruction Manual

 Before Using Your Wine Cooler/Beverage Cooler

Remove the exterior and interior packing.

Before connecting the Wine Cooler/Beverage Cooler to the power source, let it stand
upright for approximately 24 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

This appliance is intended to be used in household and similar applications such as
– staff kitchen areas in shops, offices and other working environments;
– residential homes and by clients in hotels, motels and other residential type environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.

When disposing your appliance, please choose an authorized disposal site.
 Installation of Your Wine Cooler/Beverage Cooler

This appliance is designed to be used for a free standing installation or built-in (fully
recessed. Refer to sticker location on the back of this appliance).

This appliance is intended to be used exclusively for the storage of wine or
beverages.

Place your Wine Cooler/Beverage Cooler on a floor that is strong enough to support it when
it is fully loaded. To level your Wine Cooler/Beverage Cooler, adjust the front leveling leg at
the bottom of the Wine Cooler/Beverage Cooler.

This appliance is using flammability refrigerant. Never damage the cooling pipework during
transportation. Locate the Wine Cooler/Beverage Cooler away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating
and heat sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the Wine Cooler/Beverage Cooler into a dedicated, properly installed-grounded wall
outlet. Do not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized service center.
 Attention

Store wine in sealed bottles;

Do not overload the cabinet;

Do not open the door unless necessary;

Do not cover shelves with aluminum foil or any other shelf material which may prevent air
circulation;

Should the Wine Cooler/Beverage Cooler be stored without use for long periods, it is
suggested, after a careful cleaning, to leave the door ajar to allow air to circulate inside the
cabinet in order to avoid possible formations of condensation, mold or odors.
 Ambient Room Temperature Limits
This appliance is designed to operate in ambient temperatures specified by its temperature class
marked on the rating plate.
Class
Extended Temperate
Temperate
Subtropical
Tropical

INSTALLATION INSTRUCTIONS

Symbol
SN
N
ST
T
3
Ambient Temperatures range(℃)
﹢10 to﹢32
﹢16 to﹢32
﹢16 to﹢38
﹢16 to﹢43