PTO SHAFT JOINT (DRIVE) ASSEMBLY
PTO SHA
FT JOINT (DRIVE) ASSEMBLY
PTO SHA
PTO SHA
FT JOINT (DRIVE) ASSEMBLY
FT JOINT (DRIVE) ASSEMBLY
Check that the PTO shaft does not make contact with the guards at the
•
shortest point (in general horizontal PTO shaft parallel to the PTO exit –
Fig. 4-)
If it does, reduce the tubes by the same length (cut, clean, grease)-Fig.5
•
form A to D-
It is essential that a general check be made in the event of modification of
•
the length of the third point or in the event of tractor substitution
C C C C
! ! ! ! These operations must be undertaken slowly and with the greatest of
AUTION
AUTION
AUTION
AUTION
care in compliance with the safety regulations laid down in this manual.
24