Hull; Fiberglass And Non-Skid; Carpet (If Equipped); Upholstery (If Equipped) - Nauticstar XTS Series Owner's Manual

XTS SERIES OWNER'S MANUAL
Yamaha
https://yamahaoutboards.com/en-us/home/owner-resources/all/owners-manuals
Mercury
https://www.mercurymarine.com/en/us/land/owners-manuals/

HULL

Periodic cleaning is the best way to keep your boat looking like new. Regular washing and waxing keep dirt and build-up from
deteriorating the finish. If you keep your boat in showroom-new condition, then your personal satisfaction will be higher and
the resale value of your boat will be greater. The boat is made of fiberglass-reinforced plastic resin material that is easy to
clean and care for. Several layers of resin material are chemically bonded together to form the hull. The smooth outside
surface of the hull is a layer of gel coat resin. The gel coat is a solid color that is only a few millimeters thick. Beneath the
gel coat surface is a series of layers of chemical resin, fiberglass mat and woven roving. It is these layers that give the boat
its strength and maintain the hull shape. Even though NauticStar has carefully crafted boats from resilient materials, it is
still the responsibility of the boat owner to perform regular and routine cleaning maintenance to ensure that the boat exterior,
interior and components retain both their appearance and strength.
When washing the boat, use a mild detergent, such as Dawn or Ivory dish soap, or similar commercially produced detergent,
and warm water solution. DO NOT use abrasive cleaners, solvents, ammonia, or chlorine, as these will damage the gel coat
surface. Under extreme conditions, special cleaners may be used to remove marine growth from the hull. (See an authorized
NauticStar service department for further instructions.)

FIBERGLASS AND NON-SKID

To protect your deck and non-skid areas from the deteriorating effects of the sun, oxidation, and water spots, use a good
quality "fiberglass and non-skid deck" wax every two-three months. Apply according to the manufacturer's recommendations.

CARPET (IF EQUIPPED)

Occasionally washing with mild detergent and warm water or household carpet cleaners will help keep the carpet clean.
Thoroughly hose the detergent out of the carpet and into the bilge. (This is a good time to clean the bilge also.) Allow the boat
to remain uncovered to air dry for several days to prevent any mildew or odor caused by moisture.

UPHOLSTERY (IF EQUIPPED)

While the vinyl is made to withstand the elements, it is important to care for vinyl by keeping it always clean. Many substances
may stain the vinyl if left untreated over a period of time. Remember to remove any contaminant and clean vinyl immediately.
Regular washing with mild detergent and warm water or vinyl cleaners is sufficient to keep the cushion and vinyl coverings
in good condition.
76 |
XTS SERIES P a g e