Finished Spraying - X-Stream CLEAN MicroBurst XCSAGA-2P Operation Manual

STEP 3.
AFTER YOU FINISH SPRAYING
Dispose of extra liquid/chemical based on manufacturer's
A)
instructions. Rinse out any residual solution in the spray tank
with warm, soapy water. Then spray fresh water through the
sprayer for 3 to 5 minutes to completely clear the tank, pump,
gun, wand, and any used nozzles of chemicals.
Disconnect the hose from the spray gun and let the hose
B)
hang down towards the ground in order to drain the hose of
any liquid.
Dry the sprayer tank and clear the nozzle of any buildup.
C)
14
Proper sprayer maintenance is crucial to ensure the life and performance of your sprayer. Many spray materials
can harden if left in the sprayer, causing clogs in the nozzle or hose. Gasoline should never be used to clean out
your sprayer.
Store the sprayer in a clean, dry, and shaded location to
D)
protect it from extreme heat or frost.
For long-term storage, regular charging of the battery is
*
required to maximize battery life. Check the battery level
using the indicator lights every 4 weeks. Recharge the
battery if it falls below 3 bars. Do not allow the battery to
fully discharge.
Copyright © WESSOL, LLC