Related Manuals for STERI STAND STERI STAND
Summary of Contents for STERI STAND STERI STAND
- Page 2 Congratula+ons on the purchase of your Steri Stand You will find the following components in the box for each Steri Stand • Triangular Base Plate • Upright Column STERI STAND • Foot Pedal ASSEMBLY GUIDE • Hooked Connec+ng Rod •...
- Page 3 Plunger Lever Foot Pedal Triangular Base Plate U-Clamp M5 Countersunk Screw and Wing-nut Hooked Connecting Rod Upright Column M8 Bolt, Washer & Nut Locking Pins M5 Nut Jig M5 / M8 Wrench...
- Page 4 Assembly Time: 5 minutes STEP 1-3 ATTACHING COLUMN TO BASE 1. Insert the M8 bolt from the bottom of the base plate (feet down) through the round end of the key hole. FEET DOWN! 2. Secure the upright column over the M8 bolt ensuring the square tab at the bottom of the column fits into the square part of the keyhole opening on the base plate.
- Page 5 Step 4. Installing Plunger. Place the Steri Stand upright and slide the bottle plunger through the top right slot on the front as well as through the corresponding slot on the back of the column (the face plate should be facing you), making sure the notch in the plunger lever is facing to the top. Secure the...
- Page 6 Step 5. Drop the Hooked Connecting Rod in from the top of the column between the Bottle lever plunger and the right side of the column, ensuring the hooked end rests in the notch of the bottle plunger lever. Behind...
- Page 7 Step 6. Slide the foot pedal through the bottom left slot of the upright column (Face plate facing you), making sure the notch in the plunger lever is facing to the bottom. Ensure the foot pedal slides through the bottom hook of the hooked connecting rod, moving the bottom hook over and into the notch.
- Page 8 Step 7 Install the U-Clamp on the longest slot on the front of the column. Make sure the tab on the U-Clamp is down once in the slot. The M5 screw goes into the hole on the U-Clamp and is secured by the Wing-nut from inside the column. Tab Down...
- Page 9 While keeping the bottle pump lifted against the Plunger lever, tighten the Wing- nut on the inside of the upright column to ensure that the U-Clamp cannot move. The bottle will now be correctly set for its specific pump height, and the Steri Stand can now be used!
Need help?
Do you have a question about the STERI STAND and is the answer not in the manual?
Questions and answers