Advertisement

AT 250
SAFE OPERATING MANUAL
IMPORTANT
READ OPERATING MANUAL BEFORE
OPERATING TRAP
ATLAS TRAP CO, INC.
TH
14264 SW 50
BENTON, KS 67017
TEL 316-778-2002
FAX 316-778-2001
WWW.ATLASTRAPS.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AT 250 and is the answer not in the manual?

Questions and answers

James Lechleitner
February 6, 2025

Does it matter which way roller switch is installed?

1 comments:
Mr. Anderson
February 10, 2025

Yes, the installation direction of the roller switch affects the functionality of the ATLAS TRAP AT 250. If the roller is set too high, two targets may drop, causing breakage. If it is set too low, the first target may not drop and will break when the trap cycles. Proper adjustment of the roller is critical for the trap to operate correctly.

This answer is automatically generated

Steve Bell
July 14, 2025

I have a 250 and getting no response with the pull cord. It shows 12 volts between the black and white wires. ?? the push button does work on the back of the machine. Is it suppose to have 12 volts at the pull cord. ???

Subscribe to Our Youtube Channel

Summary of Contents for ATLAS TRAP AT 250

  • Page 1 AT 250 SAFE OPERATING MANUAL IMPORTANT READ OPERATING MANUAL BEFORE OPERATING TRAP ATLAS TRAP CO, INC. 14264 SW 50 BENTON, KS 67017 TEL 316-778-2002 FAX 316-778-2001 WWW.ATLASTRAPS.COM...
  • Page 2  Remove trap from packaging.  Inspect packaging and make sure there is no damage. If any damage has occurred during shipping, contact the freight carrier and Atlas Trap Co.  Always stand at rear of trap, never on either side or in front.
  • Page 3 (If you purchased a wobble base you will need to follow these instructions) Your new Atlas wobble base will allow your Atlas Trap to throw targets in a number of different directions, both vertical and horizontal. If your Atlas Trap did not arrive mounted to the wobble base, there are a few steps you will need to take to mount the two items together.
  • Page 4 WIRELESS REMOTE 1 – 12 Volt Transmitter 1 – 12 Volt Receiver LT-100 To connect the wireless remote to your Atlas Trap: 1. Find a suitable location to mount the receiver. 2. Plug in male adapter at rear of trap.
  • Page 5 For carts that have an ATA/oscillating base: skip step 7 and proceed to step 8. 8. Mount 12”x 2” strap to long cart tongue using supplied hardware. Align center hole of strap to center hole on long cart tongue (between battery box and axel housing). 9.
  • Page 6  Targets may be thrown in rapid succession. However, continuous cycling may cause motor to overheat. Do not allow motor to overheat!  Never adjust, tamper or transport trap while cocked or connected to battery. Remember if trap is disconnected from battery it is still cocked unless it is un-cocked by you. ...
  • Page 7 Atlas Trap Co., Inc. or its officers or employees shall not be liable under any circumstances for consequential or incidental damages including but not limited to personal injury or labor cost acquired and not authorized by Atlas Trap Co., Inc.

Table of Contents

Save PDF