ATLAS TRAP PATRIOT Operating Manual

ATLAS TRAP PATRIOT Operating Manual

Safe operating manual

Advertisement

ATLAS MODEL: PATRIOT
SAFE OPERATING MANUAL
IMPORTANT
READ OPERATING MANUAL BEFORE
OPERATING TRAP
ATLAS TRAP CO, INC.
TH
14200 SW 50
BENTON, KS 67017
TEL 316-778-2002
FAX 316-778-2001
WWW.ATLASTRAPS.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PATRIOT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ATLAS TRAP PATRIOT

  • Page 1 ATLAS MODEL: PATRIOT SAFE OPERATING MANUAL IMPORTANT READ OPERATING MANUAL BEFORE OPERATING TRAP ATLAS TRAP CO, INC. 14200 SW 50 BENTON, KS 67017 TEL 316-778-2002 FAX 316-778-2001 WWW.ATLASTRAPS.COM...
  • Page 2 All personnel required to operate the trap or load targets into the magazine, should read this instruction manual and be trained by someone knowledgeable as to the safe operation of the equipment. ASSEMBLY INSTRUCTIONS  Remove trap from packaging.  Rotate throwing arm counter clock wise until straight out in front of trap. Lay trap on side.
  • Page 3: Safety Precautions

    cocking time, early motor failure, etc.  Always inspect battery clips on trap, keep them clean.  Charge battery when not in use with a trickle charger.  Trap is polarity protected. RELOADING MAGAZINE  When trap runs out of targets it is difficult to install targets while trap is in cocked position.
  • Page 4: Cart Assembly

     Targets may be thrown in rapid succession. However, continuous cycling may cause motor to overheat. Do not allow motor to overheat!  Never adjust, tamper or transport trap while cocked or connected to battery. Remember if trap is disconnected from battery it is still cocked unless it is un-cocked by you. ...
  • Page 5: Wireless Remote

    To connect the wireless remote to your Atlas Trap: 1. Find a suitable location to mount the receiver. 2. Plug in male adapter to trap. (AT50 - bottom-side of trap, AT250 & PATRIOT - rear of trap). 3. Connect red clip to positive terminal on battery. Connect black clip to negative terminal on battery.
  • Page 6: Timing Adjustment

    TIMING ADJUSTMENT To adjust the timing you will need to locate the micro switch and timing cam (see figure 1). The timing is in proper adjustment when the clay target is approx ½” from the polyurethane throwing strip while in the cocked position. This distance can vary by 1/4” either way. If the clay target is too far from the throwing strip you will need to advance the timing.
  • Page 7: Counter Balance Installation

    COUNTER BALANCE INSTALLATION When an ATA/oscillating base is added to your Atlas Model AT50 or PATRIOT, a counter balance is needed. The counter balance is going to attach to the pinch clamp which is located on the throwing arm. Please follow the steps below to install the counter balance.
  • Page 8: Warranty Information

    Shipping for warranty related items are to be paid by customer to and from factory. DISCLAIMER: Atlas Trap Co., Inc. liability under this warranty shall be solely limited to repair or replacement of products or components within the warranty period. Atlas Trap Co., Inc.

Table of Contents

Save PDF