Download Print this page

xMount Wall Secure Operating Instructions

Holds your iPad!

Table of Contents

Need help?

Do you have a question about the Wall Secure and is the answer not in the manual?

Page 1 Holds your iPad!
Page 2 Remove the holder from the packaging. xMount Wall Secure is already pre-assembled by the factory. For fastening, please screw xMount Wall Secure tightly in place at a suitable surface. For adjusting the ball joint according to your request • remove the centred cover of the holder.
Page 3 Remove the holder with parts 2 and 3 now. • Now exchange part 2 for part 4 and reassemble the parts in the sequence xMount Basis part 2 part • In this process, please pay attention to the optimal choice of the screws. Screw M 4x20 screws in the treads top right and bottom left, M 4x10 screws top left and bottom right.
Page 4 Anti-theft system The xMount anti-theft system is construed for simple theft (removal). It cannot withstand theft attempts by tools and brute force. For the anti-theft protection, please exclusively use locks of the brand Burgwächter C-Line 220-20 with a diameter of 11 mm in order to avoid the mount sliding on.
Page 5 Anti-theft system The xMount anti-theft system is construed for simple theft (removal). It cannot withstand theft attempts by tools and brute force. For the anti-theft protection, please exclusively use locks of the brand Burgwächter C-Line 220-20 with a diameter of 11 mm in order to avoid the...