IOGear GUC232A Installation Instructions

Usb to serial adapter macintosh os x installation instructions

Hide thumbs Also See for GUC232A:

Download this manual See also: Installation Manual

IOGEAR USB to Serial Adapter

Macintosh OS X Installation Instructions

NOTE: Please do not plug in your IOGEAR USB to Serial Adapter until after you have

completed the below instructions.

1) Insert the IOGEAR CD-ROM into your Mac. You will see the IOGEAR CD on your

Desktop.

2) Double-click the IOGEAR Logo, you will see the CD-ROM Contents.

3) Double-click the Mac OS 10 folder.

Page 1 IOGEAR USB to Serial Adapter Macintosh OS X Installation Instructions NOTE: Please do not plug in your IOGEAR USB to Serial Adapter until after you have completed the below instructions. 1) Insert the IOGEAR CD-ROM into your Mac. You will see the IOGEAR CD on your Desktop.
Page 2 4) You will now see the Extensions Package for Mac OS X. 5) Double-click the PL2303_1.0.0.pkg. 6) The USB to Serial Cable driver installation will appear. Click Continue.
Page 3 7) You will now be asked where you would like to install the driver package. Select the Hard Disk that contains your Mac OS X (or “10”) partition, then click Continue. 8) You will now be asked if you wish to perform a basic installation of the software package on your Mac OSX volume.
Page 4 Click OK 10) You will receive a small prompt, letting you know that your machine will be restarted after you have completed the installation of the USB to Serial Adapter. Click Continue Installation. 11) Once the installation procedure is completed, click Restart.