Citizen CLP-6401 User Manual page 52

Indication
RibonOut
OverHeat
Fan stop
OP Err
Cut Err
ROM Err
RAM Err
- -
Description
Ribbon end
PCB overheat
Fan stop
Option board
abnormality
Auto-cutter
abnormality (such as
poor engagement)
ROM checksum error
RAM checksum error
System error (such as
timer or CPU
malfunction)
Corrective actions
Check the contents and clear with the Stop
key.
Install the ribbon.
Check that the ribbon winds fully.
Correct the faulty setting of the print mode
(direct-thermal or thermal-transfer).
Turn off the power and reset the printer. If
this recurs, contact our service personnel.
Check for the fan stop caused by the problems
such as foreign matter entered in the air vent.
Automatically returned if the fan turns again.
If disassembling is needed to remove foreign
matter or the problem can't be identified,
contact our service personnel.
Turn off the power and reset the printer. If
this recurs, contact our service personnel.
Check the contents and clear with the Stop
key.
If this can't be cleared, turn off the power and
remove foreign matter from the auto-cutter.
If this recurs, contact our service personnel.
Turn off the power and reset the printer. If
this recurs, contact our service personnel.
Turn off the power and reset the printer. If
this recurs, contact our service personnel.
First protect the system, then reset the printer.
4-6