FirstBuild FORGE Use And Care Manual page 25

1. To continue making ice, simply move the ice gems from
the bottom ice shelf up to the top storage shelf or to a
secondary freezer. For best results, ice gems stored on
Forge's top shelf should be used within a few days. Add
more water, and ensure the black flaps behind the lower
shelf are reset after each ice making cycle. Reset the
flaps by gently pressing down.
Draining Water
1. To drain the Forge Clear Ice Maker, use the front drain
tube, which can be found behind the small door at the
front of the ice maker. (See Fig. 3 on page 20.)
2. After opening the door, pull out the rubber tube and
unplug the stopper at the end. Take care to keep control
of the tube so water does not spill.
3. Direct the tube to either a sink or emptying container, and
allow water to drain. For faster draining, angle drain tube
as much as possible toward the floor.
4. Once reservoir is empty, reinstall the drain tube at the
front of the ice maker to its original position. Ensure
stopper is fully installed inside tube to prevent leaking.
5. Refill the ice maker reservoir with clean water up to the
maximum fill line.
Maintaining Ice Clarity
To ensure the highest quality ice, the Forge Clear Ice
Maker should be drained completely after the creation of
approximately 24 ice gems. It is also recommended to drain
Forge's reservoir when not in use.
Forge Clear Ice Maker 25