Table of Contents
Advertisement
Model
Continuous power
Maximum power
Surge power
Output Wave
DC input(V)
DC cutout (V)
No Load Draw
AC Output
AC Sockets
AC hard wire terminals
Remote switch panel
Single digital voltage meter and LED
Display
Efficiency
THD
Output frequency
Isolation strength
Insulation method
Protection
Minimum Cable size for
DC connection
Dimensions (LxWxH)
*Specifications are subject to change without prior notice.
PROBLEM: The Inverter will not power ON, power indicator (blue) is not lit
Reason
Poor contact with battery terminals
Blown DC battery fuse(s)
24v models require remote control to power on
PROBLEM: The appliances do not work, the fault indicator (red) is lit, Audible alarm ON
Reason
Battery voltage below 10 Volts* (*20v for 24v models)
Inverter is too hot (unit is in thermal shut down mode)
The Inverter is overloaded
Unit may be defective.
(2000W - 6000W)
PI-300012
2400W
3000W
4800W
Modified
10.5 Volts (Low) & 15 Volts (High)
240 Volts (+/- 8% in accordance with Australian Voltage standards
Dual 240 Volt 10 Amp Australian standard 3 pin sockets
No
indicators
≧1500Vac/1min, Between input and output and the casing
Short circuit protection, Over load protection, Over temperature protection, Battery low voltage protection,
Battery over voltage protection, Battery low voltage warning
0 B&S
310x150x90
TROUBLESHOOTING
PS-250012
2000W
2500W
4000W
Pure
12 Volt
0.3 Amps
No
Yes – 5m cable
Dual digital voltage meters and LED indicators
≥90%
THD≤3%
50 Hz±1 Hz
Optical Coupling DC-DC-AC
1B&S
430x180x110
Solution
Shut down Inverter and disconnect. Clean terminals thoroughly and reconnect
Turn off Inverter. Replace fuse(s) with same type and rating
Connect unit to battery, then power up unit with power button on front then turn
on with remote control
Solution
Charge or replace battery
Allow Inverter to cool. Check for adequate ventilation. Reduce the load on the
Inverter to rated continuous power
Reduce the load
See Warranty and contact AllSpark® customer service
PS-500024
4000W
5000W
8000W
Pure
24 Volt
21.0 Volts (Low) & 30 Volts (High)
0.6 Amps
Yes up to 4mm2 cable input
Yes – 5m cable
3/0 B&S
490x180x140
Advertisement
Table of Contents
