Download Print this page

VELOWAVE E-Dasher Instructions To Set Up page 8

Advertisement

Option 2, to charge the battery OFF the bike (as shown in below figure)
1) Use the key to unlock the battery and take it off from the bike.
2) Place the battery in a clean and flat place in room temperature.
3) Connect the adapter cable to the charger to make them into one-piece. Insert the adapter
output plug to the battery charge port. Then connect the charger input plug to the power
supply. It starts to charge as the small LED light on the charger turns RED.
Notes:
1) Charging time varies from 6 to 10 hours.
2) The small LED light on the charger in RED indicates it is in charge; The small LED light on
the charger in GREEN indicates it is fully charged.
3) Insufficient charging will not influence the battery lifecycle. AVOIDING deep discharge is
helpful to protect the battery and extend its lifecycle.
4) If the battery will not be used for a long period, discharge its capacity to 60%-80% for stock,
disconnect it from the charger and place it in a dry, ventilated place without direct sunlight.
In order to maintain a long lifecycle, it is recommended to charge the battery every two
months.
5) Pay attention to check whether the surface temperature of the battery case rises too high
during charging. It is FORBIDDEN to cover the battery during charging.
6) Due to high temperature in summer time, it is NOT advisable to charge it immediately after
riding. In winter, it is FORBIDDEN to charge the battery in environment below 0℃. You are
recommended to charge it in warm circumstances.

Advertisement

loading