Installing Your Pedals - VELOWAVE E-Dasher Instructions To Set Up

1) Warning: Incorrect installation will cause damage. Please read the instructions and watch our
videos if needed.
2) Identify the Left and Right markings on the pedals. They can only be installed in their
respective side.
a. L is for the Left Pedal and it goes on the Left Crank Arm.
b. R is for the Right pedal and it goes on the Right Crank Arm (Chain Side)
3) Sitting on your bike the pedals go on the Left and Right side respectively.
4) Keep the pedal Horizontal while hand screwing to get the thread started. Then Use your 15mm
wrench to tighten them.
5) Both pedals tighten towards the front of the bike. The left pedal is reverse threaded to allow
this.
6) The pedals need to be very tight, be sure to retighten after your first couple rides.
Rear
Right Pedal /
Chain Side
Wrench icon made by Gregor Cresnar from

Installing Your Pedals

Use your 15mm
wrench to properly
tighten the pedals
www.flaticon.com
Front
Both pedals
tighten towards
the front
Left Pedal /
Key Side