Advertisement
Quick Links
Advertisement
Summary of Contents for VELOWAVE E-Dasher
- Page 1 Instructions to Set Up Your E-Dasher Diagram...
- Page 2 We know you are excited about getting going but please: ✓ Reseat and charge the battery before the first ride ✓ Make sure the pedals are tight ✓ Make sure the front wheel is installed properly and tight ✓ Check to be sure the tires are inflated properly ✓...
-
Page 3: Assembling Your E-Bike
Assembling Your E-Bike 1) Read all of the instructions carefully. Be familiar with the proper operation of all items. 2) This quick guide is intended to list the steps needed to assemble your bike with some mechanical skills. It is not a complete manual or training. If you do not feel comfortable or lack some of the skills to assemble it yourself, reach out to a cyclist friend, a local bike mechanic or one of our support technicians for guidance. - Page 4 Installing Your Handlebars 1) Remove the screw ① and then release the screw ② a little bit as following figure shows. 2) Insert the handlebar into the right position of the stem. 3) Tighten the screw ① first by 8-10 torque force and then tighten the screw ②. 4) Tighten the test screws ③④⑤⑥...
- Page 5 Installing Your Front Wheel - Through Axle Version 1) Insert the axle into the wheel hub as shown. Add the Slim Spacer on the LEFT side (Brake Disk) and the Wide Spacer on the RIGHT side. 2) Insert the front wheel with the spacers in between the front fork on the bike. Be sure to align the disk between the brake caliper as shown in Figure 2.
- Page 6 Installing Your Pedals 1) Warning: Incorrect installation will cause damage. Please read the instructions and watch our videos if needed. 2) Identify the Left and Right markings on the pedals. They can only be installed in their respective side. a. L is for the Left Pedal and it goes on the Left Crank Arm. b.
- Page 7 How To Use Your Bike 1) Read all instructions carefully, be familiar with the proper operation of all items. Check for detailed information and guidance on our product offer page. 2) Warning: Basic electric precautions should always be followed to avoid issues or malfunction. 3) Charge your battery fully in preparation for your first ride.
- Page 8 Option 2, to charge the battery OFF the bike (as shown in below figure) 1) Use the key to unlock the battery and take it off from the bike. 2) Place the battery in a clean and flat place in room temperature. 3) Connect the adapter cable to the charger to make them into one-piece.