Advertisement
ATTACHING TO TRACTOR
Never stand between tractor and Rotary Mower
STEP 1 Attach to the tractor's three point hitch as described in the Tractor's
Operator's Manual.
STEP 2 Apply any multi-purpose grease to the outside of the male (inner) PTO
shaft section. Assemble PTO shaft and install attach to the Rrotary
Cutter and the tractor.
WARNING
Failure to install the retaining clip on gearbox input shaft would
allow the driveline to swing freely if the bolt is sheared causing
possible injury or death.
STEP 3 Pull the shaft on the tractor side of PTO shaft yoke to be sure it has
locked in place. Make certain PTO shaft guards are in place and good
working condition.
STEP 4 The PTO shaft guard is a non-rotating design and must be secured prior
to equipment use.
OPERATING INSTRUCTIONS
This mower was designed to CUT PASTURE GRASS AND ROUGH AREAS UP
TO 1" IN DIAMETER. Use of your Rotary Cutter to cut any material larger than 1"
in diameter may damage the mower and void your warranty.
PRE-OPERATIONAL ADJUSTMENTS
Set tractor's lift control stop at a position that will prevent the PTO shaft from
coming in contact with the front edge of the mower when it is at full lift. Consult
your tractor manual for instructions.
WARNING
while backing the tractor up to the hitch
9
Advertisement
