Using This Manual; Maintenance Counters - DALGAKIRAN L-8 User Manual

USING THIS MANUAL

WHEN YOU SEE DISPLAY ADVANCE VIA BUTTONS ON THE RIGHT.
screen
1
USING THIS MANUAL : WHEN YOU SEE DISPLAY ADVANCE VIA BUTTONS ON THE RIGHT. PRESS
SIMULTANEOUSLY TO THE FRAMED BUTTONS.
FIRST PRESS LEFT-HAND SIDE BUTTON SIMULTANEOUSLY PRESS THE OTHER ONE.
PRESS ONE AFTER ANOTHER
AFTER PRESSING THE MENTIONED BUTTONS, COMPARE THE DISPLAY WITH THE MANUAL TO
VERIFY. SO YOU CAN ADVANCE STEP BY STEP.
ALSO NOT TO CONFUSE STEP NO IS WRITTEN ON THE LEFT SIDE OF THE DISPLAY.

MAINTENANCE COUNTERS

WHEN THE COMPRESSOR IS RUNNING, PUSHING
MAINTENANCE TIMERS.
1 (WORKING PRESSURE)
2 (WORKING TEMPERATURE)
3
4
5
6
7
8 (RUNNING SCREEN)
IF THE NUMBERS TO BE DISPLAYED HAVE MORE THAN THREE (3) DIGITS OR TWO DIGITS WITH
NEGATIVE SIGN (-), THE MULTIPLICATIVE FACTOR LED "X10" OR "X100" EMMITING.
WHEN THE TIMERS ARE OVER, THEY WILL GO ON AS NEGATIVE COUNTING.
(1800 HOURS, SHOWING ON THE SCREEN
IF NO ONE BUTTON IS PUSHED FOR THE NEXT 1 MINUTE, CONTROLLER GOES MAIN SCREEN
AUTOMATICALLY.
WORKING HOUR COUNTERS
WHEN THE COMPRESSOR IS RUNNING, PUSHING
1 (WORKING PRESSURE)
2
3
4 (RUNNING SCREEN)
HOURS TO THE NEXT AIR FILTER CHANGE.
HOURS TO THE NEXT OIL FILTER CHANGE.
HOURS TO THE NEXT SEPARATOR CHANGE.
HOURS TO THE NEXT OIL CHANGE.
CHECK KOMPRESSOR
(TOTAL HOURS) AND THEN THE TOTAL HOURS VALUE
(LOAD HOURS) AND THEN THE LOAD HOURS VALUE
SHORTLY, THE DISPLAY SHOWS
AND WITH "X10" LED EMMITING)
THE DISPLAY SHOWS WORKING HOURS.
6