Agilent Technologies E3632A User Manual page 5

Front-Panel Voltage and Current Limit Settings
You can set the voltage and current limit values from the front panel using the
following method.
Use the voltage/current adjust selection key, the resolution selection keys, and
the control knob to change the voltage and current limit values.
1 Select the desired range using the range selection keys after turning on the power
supply.
2 Press the
3 Move the blinking digit to the appropriate position using the resolution selection keys
and change the blinking digit value to the desired voltage limit by turning the control
knob. If the display limit times out, press the
4 Set the knob to current control mode using the voltage/current adjust selection key.
5 Move the blinking digit to the appropriate position using the resolution selection keys
and change the blinking digit value to the desired current limit by turning the control
knob.
6 Press the
display will go to output monitoring mode automatically to display the voltage and
current at the output or the display will go to output monitoring mode immediately by
pressing the
N o t e
A l l f r o n t p a n e l k e y s a n d c o n t r o l s c a n b e d i s a b l e d w i t h r e m o t e i n t e r f a c e
c o m m a n d s . T h e A g i l e n t E 3 6 3 2 A m u s t b e i n " L o c a l " m o d e f o r t h e f r o n t p a n e l
k e y s a n d c o n t r o l s t o f u n c t i o n .
4
key to show the limit values on the display.
Display Limit
key to enable the output. After about 5 seconds, the
Output On/Off
key again.
Output On/Off
key again.
Display Limit