Page 1
Cold Frame Assembly Instruction Overall Size/CM: L180 x W51 x H51 Overall Size/inch: L70"x W20"x H20" 9820113 IMPORTANT You must read these instructions carefully before you start to assemble it. Please ensure that you find all parts in the correct type and quantity as mentioned in the list.
Page 2
IMPORTANT If you have any problems with this product, please DO NOT RETURN THIS ITEM To the Retailer/Store from where you purchased the product. Please email us anytime with the nature of the problem at: ContactUs@Hanover‐Products.com Please include: Pictures of the issue(s) and receipt (if available) Name and address of the Purchaser Name of retailer Or call our Customer Service team between 9:00 AM and 5:00 PM Eastern Time, Monday through Friday at: 1‐877‐397‐5144 or visit our website at: www.Hanover‐Products.com To expedite any future warranty claims, please retain your receipt for future use. For additional on‐line support on assembly, troubleshooting and care & maintenance of your outdoor product, please visit our website at: www.Hanover‐Products.com. 8/1/2019 ...
BEFORE YOU START Owner's Manual Assembly instructions Instructions are supplied in this manual and contain all appropriate information for your building model. Review all instructions before you begin. During assembly, follow the step sequence carefully for correct results .Please be aware: Parts Check to be sure that you have all the necessary parts for the building.
Window Assembly Please note that the parts W2 should installed on the two short edges of the window. Insert the other end of Assemble W5 and W6 Connect W1 and W2 with F2 W2 and W3 into corner screw at each corner. guard W4.
Page 6
Frame Assembly & Wall panels Installation Insert part 1# & 2# into Step III: the groove of corner seat S1. Step 1: Insert corner posts 3# and 4# into each corner guard S1 and fix them with 1 piece F2 screw. Step IV: Insert part 1# &...
Page 7
Window Assembly Insert the hump on the part S3 into the circled groove of W1. Insert the hump on the part S3R and S3L into the circled groove of W1.
Page 8
Window Installation and Screwing Install the cover and window combination kit onto the assembled frame. Insert the parts 3# into the part S3L,S3 and S3R, and the parts 4# into the part S2L/R and S2. Fix each part S2L/R,S2 and Fix each part S3L/R,S3 with 1 F2 screw.
Maintenance: 1.Please prevent adding any increased weight to the product. PC Panel Maintenance: 1. Be careful not to have a sharp object touch the film as it may scratch. 2.Clean films regularly to keep the light transmittance as clear as possible. 3.The boards/panels have flame retardant polycarbonate material applied to them and is recommended to keep away from fire to avoid softening or deformation.