Sealey CP20VOS Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1. SAFETY
1.1. GENERAL SAFETY
WARNING! ensure that Health & Safety, local authority and general workshop practice regulations are adhered to when using this
‰
sander.
Familiarise yourself with the application, limitations and potential hazards of the sander.
9
WARNING! disconnect from the battery and ensure that the pad is at a complete standstill before changing accessories,
‰
servicing or performing any maintenance.
maintain the sander in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
WARNING! Keep all holding screws in place, tight and in good working order. Check regularly for damaged parts.
‰
A part that is damaged must be repaired/replaced before the sander is next used.
Use the sander in a suitable work area and keep the area clean and tidy and free from unrelated materials. ensure that there is
9
adequate lighting.
Keep the sander clean for best and safest performance.
9
Before each use check all attachments for condition. If worn or damaged replace immediately.
9
ensure that there are no flammable materials near the work area.
9
WARNING! Wear approved safety eye protection, ear defenders and, if dust is generated, respiratory protection.
‰
maintain correct balance and footing. ensure that the floor is not slippery and wear non-slip shoes.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain and/or tie back long hair.
9
Keep children and unauthorised persons away from the work area.
9
Avoid unintentional starting.
9
DO NOT use the sander for any purpose other than that for which it is designed.
8
DO NOT operate the sander if any parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT get the sander wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT allow untrained persons to operate the polisher.
8
DO NOT operate the sander when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT use the sander where there are flammable liquids, solids or gases such as paint solvents, etc.
8
DO NOT leave the sander operating unattended.
8
DO NOT carry the sander with your finger on the power switch.
8
Use a qualified person to maintain the sander.
9
When not in use, remove and store in a safe, dry, childproof area.
9
1.2. LEAD PAINT WARNING!
Paint once contained lead as a traditional ingredient. Contact with the dust from the removal of such paint is toxic and must therefore
be avoided. The following action must be taken before using the sander on a surface that you suspect may contain lead paint.
1.2.1. User must determine potential hazard relating to age of paint to be removed.
(modern paints do not have lead content).
▲ DANGER! Keep all persons and pets away from the working area. The following persons are particularly vulnerable to the effects of lead
paint dust: Expectant women, babies and children.
1.2.2. We recommend personal protection by using the following safety items:
a) Paint Spray Respirator (our ref SSP1699)
b) Pe Coated Hooded Coverall (our ref SSP266).
c) latex Gloves (our ref SSP24).
1.2.3. Take adequate measures to contain the paint dust, flakes and scrapings.
1.2.4. Continue to wear safety equipment as in (3) above and thoroughly clean all areas when task is complete. ensure paint waste is disposed.
of in sealed bags or containers according to local regulations.
9
9
9
© Jack Sealey limited
ORBITAL PALM SANDER 20V 125MM -
BODY ONLY
CP20VOS
model no:
Wear a Wear ear
mask protection
Original Language Version
Wear
protective
gloves
CP20VoS | Issue 1 10/04/18