Table of Contents
Advertisement
Infra-Red (IR) remote control sensor is located on the front of the projector. The
remote control must be held at an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly. The distance between the
remote control and the sensor should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor
on the projector that might obstruct the infra-red beam.
Replacing the remote control battery
1.
To open the battery cover, turn the remote control over to view its back, push
on the finger grip on the cover and slide it up in the direction of the arrow as
illustrated. The cover will slide off.
2.
Remove any existing batteries (if necessary) and install two AAA batteries
observing the battery polarities as indicated in the base of the battery
compartment. Positive (+) goes to positive and negative (-) goes to negative.
3.
Refit the cover by aligning it with the base and sliding it back down into position.
Stop when it clicks into place.
•
Avoid excessive heat and humidity.
•
There may be battery damage if the battery is incorrectly replaced.
•
Replace only with the same or equivalent type recommended by the
battery manufacturer.
•
Operating the projector from
the front
Introduction 15
Advertisement
Table of Contents
