Quick Start Tutorial - Signal Wizard Systems Vsound 2 Manual

5
3.

Quick start tutorial

Ensure your computer or laptop has internet access. If you are reading this then you will have already
downloaded and installed the vsound software from the website, and the vsound software is open.
Now follow these steps:
Connect the supplied power adaptor to vsound and switch on (do not use any other adaptor).
Connect vsound to the computer using the USB cable provided.
The drivers for the USB communication will automatically be installed from the internet. Do not
proceed until this stage has been completed.
Click the "Detect" button in the Notifications and system window. The system will search for the
vsound pedal, and will typically report the following messages:
Detecting hardware...
Hardware found.
Resetting system...
Testing status...
Communications: OK
Firmware version: 2.5
Start up mode: Saved settings
Volume: 5
Mixer wet: 100
Mixer dry: 0
Selected response: Bypass
Reset sequence complete.
Your vsound pedal is now fully set up and ready to go.