Download Print this page

Advertisement

Quick Links

Hanover Outdoor Furniture 
If you have any problems with this product (missing or damaged parts, assembly issues, etc.), 
PLEASE DO NOT RETURN TO THE RETAILER/STORE
Please call our Toll‐Free Customer Service Hotline at: 
Between 9:00 AM and 5:00 PM Eastern Time, Monday through Friday 
Or visit our website at:   
 
To expedite any future warranty claims, please retain the Instruction Sheet, Warranty 
Card and receipt for future use. 
For  additional on‐line support on assembly, troubleshooting and care & maintenance of your outdoor 
furniture, please visit our website at:    www.hanover‐products.com.
 
 
 
IMPORTANT 
from where you purchased the product.     
www.hanover‐products.com
 
 
1‐800‐416‐3511
 
 
   
 
 
 
6/1/2015 (a) 

Advertisement

loading

Summary of Contents for Hanover TRAD5PCCFP-RED

  • Page 1   Hanover Outdoor Furniture          IMPORTANT  If you have any problems with this product (missing or damaged parts, assembly issues, etc.),  PLEASE DO NOT RETURN TO THE RETAILER/STORE     from where you purchased the product.      1‐800‐416‐3511 Please call our Toll‐Free Customer Service Hotline at:    Between 9:00 AM and 5:00 PM Eastern Time, Monday through Friday  www.hanover‐products.com   Or visit our website at:        To expedite any future warranty claims, please retain the Instruction Sheet, Warranty  Card and receipt for future use.    For  additional on‐line support on assembly, troubleshooting and care & maintenance of your outdoor  furniture, please visit our website at:    www.hanover‐products.com.   6/1/2015 (a) ...
  • Page 2 PARTS IDENTIFICATION LIST * NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE PARTS LIST DESCRIPTION ORDER PART # FOOT CAP FC0030 FACTORY ASSEMBLY AAF06000 Page 4...
  • Page 3 ASSEMBLY INSTRUCTIONS ARL00100 CSA Model 99000 Installer: Leave these instructions with consumer. Consumer: Keep these instructions for future reference DANGER   WARNING:  If you smell gas: Improper installation, adjustment alteration, 1. Shut off gas to the appliance. service or maintenance can cause injury or 2.
  • Page 4: Parts Identification List

    PARTS IDENTIFICATION LIST PART DESCRIPTION PART# CONTROL KNOB FP1245 GAS VALVE FP0307 THERMOCOUPLE FP0004 LP REGULATOR 65-FP-0181 HOSE ELECTRODE 65-FP-0128 ORIFICE ELBOW FP0310 IGNITION MODULE FP0006 PROPANE ZCF0021 ORIFICE “AAA” HW0705 BATTERY(1.5V) LAVA ROCK SET FP0002 FOOTCAP FC0559 1/4" X 15 MM BOLT HW0034 1/4"...
  • Page 5 FIREPIT TABLE BACK PANEL LEFT SIDE PANEL RIGHT SIDE PANEL DOOR PANEL MIDDLE SUPPORT LP SUPPORT BOTTOM/ TOP CONNECTOR...
  • Page 6: Installation

    INSTALLATION 1.Identify parts packed in carton against the parts list. Remove all protective materials and set parts on a flat, non-abrasive surface. 2. Attach the back panel to the side panels by using four 1/4"x40 mm bolts and washers as shown in Figure 2.Guide the bolts through the holes in back panel, into the pre-drilled holes in the side panels.
  • Page 7 5. Put the door onto the bottom connector, guide the pin in the bottom connector into the hole on the underside of the door. Then guide the pin on the top connector into the hole in the topside of the door, use a 1/4"x15 mm bolt and washer to attach this top connector to the right side panel as shown in Figure 5.
  • Page 8 7. Attach the LP support the to door panel by using four 1/4"x15 mm bolts and washers as shown in Figure 7. Do not over tighten. Figure 7 8. Place gas tank onto the LP support as shown in Figure 8. Figure 8 9.
  • Page 9 Figure 9a Figure 9 Figure 10 10. After making any necessary adjustments to the parts, use the hex bolt driver to tighten all bolts. Note: each bolt must be tightened a few revolutions at a time. Repeat until all bolts are tight. Do not over tighten. Over tightening may strip bolts. Cover all bolts with covers.
  • Page 10 13. Remove the cardboard cover from the ignition well as shown in Figure 12. Remove any lava rock or fire ice on top of ignition well. Cardboard Cover Figure 12 14. Open the tank valve. Apply a solution of soapy water to the tank-regulator connection and to the valve-hose connection to check for leaks as shown in Figure 13.