Settings - Blue by ADT S40LR0-01 Setup Manual

3. The blue LED will blink for 3 seconds when the device is successfully reset.
4. The sensor is now reset to factory default and will initiate pairing mode.
Note: If the sensor is reset while already paired to your account, it will be removed and will need
to be set up as a new device.
To reboot your device:
1. Open the sensor's top cover.
2. Remove the CR123A battery.
3. Wait 10 seconds, and then reinsert the battery.
4. The sensor should illuminate the blue LED once when boot-up/initialization tasks are complete.
5. Place the cover back on the sensor.
Battery replacement:
Open the sensor's top cover.
•
•
Insert the replacement battery correctly.
•
Blue LED starts blinking when it is ready to join the Blue by ADT system.
•
Close the sensor's top cover.
Note: Replace the battery with a CR123A battery only.
5.0

Settings

The Blue by ADT application presents a menu for accessing the Settings of the system. Swipe to reach
Settings icon, enter the Master Code, and select the device you wish to edit. The available settings are
presented below for each type of device. Each setting is found on the appropriate menu.
Blue Smart Home Hub
Name (16-character limit)
Device Type
Chime Enabled
Entry Tone Enabled
Away Exit Tone Enabled
Stay Exit Tone Enabled
Alarm Siren
Blue Keypad
Name (16-character limit)
Device Type
Chime Enabled
Panic Enabled
Entry Tone Enabled
Entry Away Tone Enabled
Entry Stay Tone Enabled
Alarm Siren
Blue Door & Window Sensor
Name (16-character limit)
Device Type
Placement
Alarm Type
Alphanumeric
Smart home hub (display only)
Yes | No
Yes | No
Yes | No
Yes | No
Yes | No
Alphanumeric
Keypad (display only)
Yes | No
Yes | No
Yes | No
Yes | No
Yes | No
Yes | No
Alphanumeric
Door & window sensor (display only)
Door | Window | Other
Stay and Away | Away Only | Convenience
37 8/7/2020