Fosworks OMNI Tx-4.2 Quick Start Manual

OMNI Tx-4.2DCC
You no longer need that big transmitter anymore! The programmable OMNI Tx-4.2
handheld transmitter will control your garden railway electric locomotives perfectly
from the palm of your hand. An Omni Rx-4 receiver with be needed to work with the
OMNI Tx-4.2 transmitter in DCC mode, but the Tx4.2 will also operate our standard
r/c Rx2 receivers installed in analogue DC models.
2.4GHz gives perfect glitch free control for up to 800 metres range with no
obstructions.
The Regulator Knob controls speed and direction is controlled be the Reverser
switch. Cruise control is possible by turning off the transmitter while the train is run-
ning. Turn back on to instantly regain control.
FUNCTION Buttons 1.2.3 /
Buttons 1.2.and 3. Operate functions 1-12 in conjunction with the two shift buttons.
These buttons are also used to re-program a receiver.
Functions 4,5,and 6 are operated by holding the
and 9 by holding the red shift button first and functions
down both shift buttons before pressing the function button required.
LED's 1 & 2
Indication of battery
and radio status plus
indications during
bind and calibration.
ON/OFF
Slide Switch
Slide down for ON
InertiaKnob
Use it to match the
DCC sounds for
super smooth accel-
eration and deceler-
ation. Turn to Zero
to switch off as
shown
2 x AAA
Battery box lid
If Alkaline batteries are used up to 100 hours of continuous
use is possible
2.4GHz Handheld Transmitter
4.5.6 / 7.8.9 / 10.11.12
green shift button first, buttons
10,11 and 12 by holding
Reverser Switch
Select forward, OFF or
reverse
Shift Buttons
Green and
Enable F4 to F12 in combi-
nation with black buttons.
Regulator
Knob
Turn fully ANTICLOCK-
WISE for OFF and fully
CLOCKWISE
power.. The further you
turn, the faster the loco
goes. Perfect
control to the exact posi-
tion shown on the regula-
tor dial. This knob is also
used when reprogram-
ming the top buttons.
OMNI Tx-4.2
Programmable 2.4GHz Transmitter
For electric models with DCC
decoders and ESC, with Inertia
Or analogue DC models with up to 12 functions
7,8
Full travel Regulator Knob plus Reverser switch
Inertia control for super smooth acceleration and braking
Plus 12 function
2.4GHz Blue Tooth Technology by Timpdon Electronics
Requires an OMNI Rx4 or Rx24 receiver with DCC interface module or
Red
Rx-24 receiver circuit diagram for use with a DCC Interface module.
for full
smooth
DCC
P.O.Box 675
Blackburn, Lancs.
BB1 9DL
UK
buttons for DCC
User programmable.
OMNI Rx2 with optional MCS switchers
or DC operation