Drive Chain Slack - Yamaha TT250RX 2007 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
1
2
To check the drive chain slack
1. Place the motorcycle on the side-
stand.
3
NOTE:
When checking and adjusting the drive
4
chain slack, there should be no weight
on the motorcycle.
5
2. Shift the transmission into the neu-
tral position.
6
3. Move the rear wheel by pushing
the motorcycle to locate the tight-
7
est portion of the drive chain, and
then measure the drive chain slack
as shown.
8
Drive chain slack:
9
35.0–50.0 mm (1.38–1.97 in)
EAU22760
1
EAU22773
1. Drive chain slack
4. If the drive chain slack is incorrect,
adjust it as follows.
To adjust the drive chain slack
1. Remove the cotter pin from the
axle nut, and then loosen the axle
nut.
2. To tighten the drive chain, turn the
adjusting plate on each side of the
swingarm in direction (a). To loos-
en the drive chain, turn the adjust-
ing plate on each side of the
swingarm in direction (b), and then
push the rear wheel forward.
NOTE:
Make sure that both adjusting plates
6-21
are in the same position for proper
wheel alignment.
1
(b)
1. Cotter pin
2. Axle nut
3. Adjusting plate
EAU22910
CAUTION:
Improper drive chain slack will over-
load the engine as well as other vital
parts of the motorcycle and can lead
to chain slippage or breakage. To
prevent this from occurring, keep
the drive chain slack within the
specified limits.
3. Tighten the axle nut to the speci-
fied torque.
(a)
2
3
ECA10570