BluWater Technology Genesis Blu Fusion User Manual page 9

BLU FUSION User Manual
Genesis
CLEANING THE SPAS FILTERS
FILTER MAINTENANCE: Filters should be cleaned monthly in ALL Spas. Remove the spa filter(s) from
your spa and immerse in a 5-gallon bucket of clean water. Then add a filter cleaner with NO
PHOSPHATES and NO PHOSPHONIC ACIDS to the water. Follow the instructions on your filter cleaner
product. It is recommended to keep a second filter or set of filters that can be rotated out during the
cleaning process. It is important to let filters dry naturally which extends the life of the filter.
IMPORTANT POINTS TO REMEMBER
► The appropriate power setting for your system will depend on how often you use your spa. A
spa with a higher-than-average bather load will require a higher setting (7-9 usually). This
simply means that the system needs to produce more bromine to maintain the level between 3
and 5 PPM/mg/L."
► It is important for all spa users to shower before entering the spa to minimize contaminates:
phosphates, deodorants, sprays, oil, skin flakes, hair, etc.
► For the occasional heavy bather load press the "BOOST" key instead of adjusting the setting.
► Sodium Bromide does not evaporate or deplete from usage. Na Br levels will reduce from
your spa because of water carry out and splash out. If bromine production becomes a
question, test for Sodium Bromide level to ensure the Na Br levels are adequate.
► With the Genesis BLU FUSION System, draining and cleaning the spa is recommended at least once per
year. Follow the start up instructions.
► For SAFETY reasons it is very IMPORTANT to test the bromine level
after using the spa will give you a lower bromine reading. The system goes back to work
over the next 24 hours of circulation and brings the bromine level back to normal.
Vacation or NON-USE of Spa: If the spa will not be in use for an extended period of time, lower the
►
power setting to½ the normal setting to prevent elevated bromine levels.
► The system only creates bromine when the circulation pump is "ON".
► The system controller should only display LED readout during low-speed circulation. When the display
is visible, bromine is being produced.
► Only use a Non-Chlorine Shock when shocking the spa, and
ANY KIND IN A SPA OR HOT TUB.
► If phosphates are present do not drain your spa and start over, as phosphates may still be
present. Add a phosphate remover and let the spa circulate for 24 hours.
phosphates by thoroughly cleaning the filter.
► Clean the filter thoroughly every 30 days.
before
NEVER USE CHLORINE OF
9
spa use. Testing
Remove the