Advertisement
3.0 OPERATION & MAINTENANCE
WARNING
Before Installation
: Inspect the power conditioner for any physical damage. If any damage is
visible do not use the power conditioner and contact the seller immediately.
CAUTION
:
Environmental Conditions
The NXT POWER Conditioner is designed only for installation
in an indoor, temperature and humidity-controlled environment. Install the power conditioner
away from heat, moisture, and dust sources.
WARNING
TIP
Ensure the unit has a minimum of 3 inches (75mm) of clearance on all sides of the unit. Do not
block any of the air vents or place objects next to or on top of the unit.
Place the NXT POWER Conditioner as close to the load equipment/electronic devices as
possible. Plug in all electrical devices that you would like to protect from electrical noise into the
power conditioner. Ensure the power conditioner is not overloaded. This can be done by
making sure the power conditioner is not loaded above its maximum rating (please see back
panel of the unit for rating information). If you have any questions regarding the rating of the
unit, please contact the seller.
Power Conditioner Voltage and Power Rating:
It is important to choose the correct
power conditioner for your application. In this manual you will find the voltage and power rating
information for the model power conditioner you have. Ensure the power conditioner is correctly
rated for your application. If you have any questions in this regard contact the seller.
Place the power conditioner as close to the load equipment (the equipment you
Installation:
want to power from the power conditioner) as possible. Plug the load equipment/electronic
devices into the power conditioner. Using the input power cord that is provided with the power
conditioner plug on end into the power inlet of the power conditioner. Then plug the power cord
into a correctly rated and wired outlet.
3
Advertisement
