Table of Contents
Advertisement
2
Installation and Assembly
2.1 Mechanical
Place the PA Adjustable Stock Reel so that the centerline of the coiled material is in line with the centerline of
the press and remaining process equipment.
The fixed base must be lagged to the floor. To prevent accidental tipping of the unit, minor dislocation from
its working spot by bumping from coil handling equipment or from banging the unit against its mechanical
stop during turn around with a heavy coil on the reel.
2.2 Electrical
See schematic.
3
Setup and Operation
Non-Motorized Stock Reel
A manually adjustable double brake shoe is mounted near the rear of the unit. This brake controls the mandrel
rotation when a straightener is pulling on the coil.
Motorized Stock Reel
A hydraulic pump powers the rotation, expansion and hold down arm of the mandrel while a loop control
device controls the mandrel speed.
Pressure Arm (Option)
The pressure arm is used to prevent a coil of material from clock springing. A pneumatic cylinder pushes
against the pressure arm forcing the urethane roller against the coil.
Additional Wedges (Option)
These wedges get screwed onto the three mandrel jaws enabling the inside of the jaws to increase coil ID by 4"(100mm).
The machine is operated using the commands on the control box and jog pendant.
CONTROL/DEVICE
Power On/Reset button
Start/Stop button
For/Rev button
Emergency Stop button
Jog Pendant
F o r m X X X X :
Warning:
DESCRIPTION
Turns controller on; resets the AC drive.
Allows the reel to unwind by instruction from the
loop control; ceases movement of the reel.
Changes the direction of the mandrel.
Shuts controller off.
Jogs the mandrel in either direction via the For
(Forward) and Rev (Reverse) buttons.
R e v i s e d
2 0 1 8
Page 5
Advertisement
Table of Contents
