Positioning The Car Seat - Toco Looka Instructions Manual

Positioning the car seat

The child car seat MUST ONLY ever be used on a forward facing passenger seat WITHOUT an active airbag.
Whilst in group 1 mode, the child car seat can only be installed using the ISOFIX anchor points WITH the top
tether. It MUST NOT be installed with out the top tether whilst in group 1 mode.
Whilst in group 2 and 3 modes, the child car seat can be installed using either the ISOFIX anchor points or the
vehicle's 3-point seatbelt.
WARNING! The top tether MUST NOT be used if installing the seat using only the 3-point seatbelt.
WARNING: Never attempt to use a 2-point seatbelt to secure the seat.
WARNING: Never use on a seat with an active airbag.
WARNING: Never use on rearward or side facing vehicle seats.
Position
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Back left & right seats
Back centre seat
Side or rear facing seats
* If fitting the car seat using ISOFIX in group 1 mode, then your
vehicle MUST have top tether anchor points and you MUST use the
top tether system.
The top tether is not necessary in group 2 & 3 modes .
The top tether MUST NOT be used for non-ISOFIX installation.
1. To check if you have ISOFIX points,
feel between the joint of the passenger seat
back and passenger seat base (A) for two
metal brackets similar to (B). If unsure
or in any doubt then consult your vehicle
manufacturer.
Seat belt type
ISOFIX*
3-point 2-point
Yes Yes
NO NO
Yes Yes
Yes Yes
NO NO
A
NO
NO
NO
NO
NO
B
7