(909) 628-8942 FAX (909) 590-4910 (800) 395-9229 General Instructions THIS BOOKLET CONTAINS INFORMATION ON: ASC-LG / ASCS-LG Lift-up curved and straight glass refrigerated service Gelato and Ice Cream Merchandiser SHIPPING DAMAGE All equipment should be thoroughly examined for shipping damage before and during unloading.
Rev. 0506 Lights (T-8) optional pans " " " ASC-LG Gelato Service Case Scale = 1/2" Lights (T-8) optional pans " ASCS-LG Gelato Service Case With Straight Glass Option Scale = 1/2" LOCATION The refrigerated merchandisers have been designed for use only in air conditioned stores where tempera- ture and humidity are maintained at or below 75°F and...
After cases have been leveled and joined, and refrig- eration, electrical, and wasted piping work completed, install the splashguards. Fasten along the top edge, or center, with #10 X 3/3” sheet metal screws. ASC-LG / ASCS-LG-0506 oiNt loor GLASS BREAKAGE...
Rev. 0506 WASTE OUTLET AND P-TRAP The waste outlet is located off the center of the case on one side allowing drip piping to be run lengthwise under the fixture. A 1-1/2” P-trap and threaded adapter are supplied with each fixture. The P-trap must be installed to prevent air leakage and insect entrance into the fixture.
PIPING The refrigerant line outlets are located under the fixture at the left end when viewed from the back. Insulate suction lines to prevent condensation dripping on the floor. ASC-LG / ASCS-LG-0506 Standard Case T-Stat Location Ballasts Gelato Case T-Stat Location...
Actual ampere draw may be less than specified. Field wiring from the refrigera- tion control panel to the merchandisers is required for refrigeration thermostats. Most component amperes are listed in the “Case Specs” section, but always check the serial plate.
User Information, Cont’d CLEANING Hussmann recommends using a clean damp cham- ois, or a paper towel marked as dust and abrasive free with 210 ® by calling Sumner Labs at 1-800-542-8656. Hard, rough cloths or paper towels will scratch the acrylic and should not be used.
COPPER COILS The copper coils used in Hussmann merchandisers may be repaired in the field. Materials are available from local refrigeration wholesalers. Hussmann recommends using #15 Sil-Fos for re- pairs.
Rev. 0506 GLASS REPLACEMENT AND ADJUSTMENT INSTRUCTIONS In order to replace or adjust the glass, the glass must be placed in the raised position. The underside of the clamp is exposed, revealing the tightening screws. By turning these screws counterclockwise 1/4 turn each, the glass will be loosened for either removal or adjustment.
The installer is responsible for following the instal- Appendices lation instructions and recommendations provided by Hussmann for the installation of each individual type refrigerator. Refrigeration piping should be sized according to Hussmann’s equipment recommendations and installed in accordance with normal refrigeration practices.
CFC-12, CFC-502 or other refrigerant? If so, have the modifications been made in accordance with the recommendations of Hussmann’s equipment ? Is the refrigerator charged with the proper refrigerant and lubri- cant? Does the system use the recommended compressor? APPENDIX D.
Load levels as defined by Hussmann must be observed. The best preservation is achieved by following these rules: a) Buy quality products.
Page 36
The MODEL NAME and SERIAL NUMBER is required in order to provide you with the correct parts and information for your particular unit. They can be found on a small metal plate on the unit. Please note them below for future reference. MODEL: SERIAL nuMBER: ASC-LG / ASCS-LG-0506...