Connecting The Scanner To The Macintosh Computer - AGFA SNAPSCAN E42 Owner's Manual

Connecting the Scanner to the Macintosh
Computer
Caution: For your safety, use the adapter that comes with this product. Do not use any substitute.
Misuse of the power adapter can cause serious damage to the product and a safety hazard while
using it.
Note: Check if the AC Adapter complies with your local power supply.
#
Note: Make sure the scanner is unlocked (see
#
the electric outlet.
1 Connect the Transparancy option as shown in the figure below (e52 only).
2 Connect the plug of the AC adapter to your scanner.
3 Plug the adapter cable in the wall outlet.
4 Connect one end of your USB cable to the USB port on your scanner.
Make sure you connect the correct plug as shown in the figure below.
5 Connect the other end of your USB cable to a USB port on your computer.
Make sure you connect it to the correct port as shown in the figure. A USB port is marked with
the USB icon ( ).
Unlocking the Scanner) before connecting it to
Chapter 4: Installing the Scanner for Macintosh 38